Tools

Cable Sizing Application


Click here to use our cable sizing application

What Changed

To focus all our efforts on our new application, we have retired our myElectrical.com cable sizing calculator. We recommend you now use our main cable sizing application over at myCableEngineering.com.

myCableEngineering.com

Cable Sizing Software - select, size and manage your power cables using myCableEngineering. All your cables, for all your projects.
  • LV and MV cables up to 33 kV with current capacity in accordance with BS 7671, ERA 69-30 and IEC 60502.
  • Positive and zero sequence impedance to IEC 60609. Voltage drop in accordance with CENELEC CLC/TR 50480.
  • Project management and team collaboration, with clear, easy-to-read calculations and reports.

Our software is the only cloud-based solution and has been built from the ground up to be fully responsive - meaning you can access your cables from anywhere and on any device, desktop, tablet or smartphone.

Complex Number Calculator

x =  
 + i  
     decimal places    
y =
 + i
   
         
x = 0.000 + i 0.000   [= 0.000 @ 0.000o]
y = 0.000 + i 0.000   [= 0.000 @ 0.000o]
1/x = NA
1/y = NA
x+y = 0.000 + i 0.000   [= 0.000 @ 0.000o]
x-y = 0.000 + i 0.000   [= 0.000 @ 0.000o]
x*y = 0.000 + i 0.000   [= 0.000 @ 0.000o]
x/y = NA
Electrical:   x = 0.000 @ a power factor of 1.000
y = 0.000 @ a power factor of 1.000

m = 0.000 + i 0.000   [= 0.000 @ 0.000o]

Tip: registered users can save calculations.

Dielectric loss in cables

Dielectrics (insulating materials for example) when subjected to a varying electric field, will have some energy loss.   The varying electric field causes...

Photovoltaic (PV) Panel - Performance Modelling

In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced.  In particular...

Battery Sizing

This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.

Electromechanical Relays

Electromechanical relays have been the traditional backbone of electrical protection systems.  While over recent years these have been replaced by microprocessor...

Induction Motor Equivalent Circuit

Induction motors are frequently used in both industrial and domestic applications.  Within the induction motor, an electrical current in the rotor is induced...

Voltage Levels – Confused?

I was having a conversation the other day about voltage levels.  While everyone was in agreement that low voltage was 1000 V and less, there was more confusion...

MIT OpenCourseWare

MIT OpenCourseWare, makes the materials used in teaching all MIT subjects available on the Web, free of charge, to any user in the world.

Cost Performance and Time

Often us engineers get so bogged down in equations, using software, producing drawings and writing specifications that this becomes the sole focus.   ...

Hazardous Areas – IEC and NEC/CEC Comparison

Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...

Equipment Verification (to IEC Standards)

One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...

Footer
(click here to extend)
Copyright (c) 2026 myElectrical